Table of Contents
Advertisement
location. After the GPS Chart Plotter has received a PTX MOB alarm, using the ShuttlePoint
knob move the cursor over the PTX to navigate to and then two Soft Keys under the display
will be shown:
a. [G
], when pressed will start navigating to the PTX MOB location
OTO
b. [L
], when pressed will show the MOBILARM Alarm Status List page. Refer to Par.
IST
16.4.2 for Alarm Status List.
If the navigation is set to the selected PTX icon, to terminate the navigation press
[S
G
].
TOP
OTO
16.4.2 The MOBILARM Alarm Status List
The MOBILARM Alarm Status List shows the list of all PTX that the GPS Chart Plotter has
received an alarm from. To review the page:
1. Select the Chart Page.
2. Press [MENU] to show the Main menu.
3. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT].
4. Move the ShuttlePoint knob to highlight MOBILARM and press [ENT].
CP390i and CPF390i
Figure 16.4.1 - Example of Goto PTX
Figure 16.4.1a - Example of Stop Goto PTX
Page 127
Advertisement
Table of Contents
