Cursor Window ON
CURSOR POSITION
COG TIME LINE
The available Units of Measure for Distance are: Nm, Sm, Km, Nm+Ft, Nm+m. Note when "Nm+Ft"
is selected if the distance is less than 1.0 Nm, it turns to Feet. When "Nm+m" is selected if the
distance is less than 1.0 Nm, it turns to Meters.
3.9
ABOUT PAGE
From Main Menu page it is possible to select the About page containing Software, Chart and
optional devices information.
1
Software System Information
2 Cartography Information
3 Storage Capacity
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight About... and press [ENT] or move the
ShuttlePoint knob to the right.
3. The Information page appears on the screen (see the previous Figure).
4. Press [CLR] or move the ShuttlePoint knob to the left to exit and show the Chart page.
CP390i and CPF390i
WAAS 3D
The position of the cursor can be customized so it is centered in the middle (if Center
selected) or centered on the bottom of the Chart page (if Bottom selected, default).
It is a line projected from the ship icon which indicates the distance your vessel will travel
at the current speed. Selections are 2, 10 (default), 30 minutes, 1, 2 hours and infinite.
NOTE*
Figure 3.9 - Example of About page
Cursor Window OFF
XXXXXX
INTCHART 1
: WW-M012.03 MARINE FRESHWATER WWBK
BUILT-IN CHARTS: NA-Z010.00
C-CARD
: M-NA-M632.00 LOS ANGELES and SAN PEDRO BAYS
WAAS 3D
YY.YY
Page 43
1
2
3