Table of Contents
Advertisement
the Soft Keys will be assigned this way: [F
on, the functioning is identical to case II.
When the PIP video window is shown, the ShuttlePoint knob can be used to move the position of the
PIP window or move the cursor around the Chart page. By default the PIP window is controlled by
the ShuttlePoint knob. To change so the chart cursor can be moved, press any Soft Key, then press
[V
P
]. To change back to control the PIP window press any Soft Key, then press [V
ID
AGE
When the PIP window is shown, the cursor and the vessels position may be shown under the PIP
window.
2.13
DEMO MODE (FOR DEALER USE)
In Demonstration Mode the GPS Chart Plotter automatically places a Destination point on
the Chart page and simulates navigation to the point. Also, the active page displayed on the
screen changes every 10 seconds. The pages are shown in the following order: Start-up
screen, GPS Status page, Chart/Compass tape page, Chart/Fish Finder page, Fish Finder
Full page, Radar page, Navigation page, Highway Page, Celestial page, NMEA Display
page.
This mode is used by dealers to promote the features of the CP390i or CPF390i when on a retail
shelf.
The Demo mode can be selected from the Simulation Menu following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SIMULATION and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight DEMO MODE and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to select ON and press [ENT] or move the ShuttlePoint
knob to the right.
6. Demo mode is now activated.
Once the Demo Mode is enabled, it is possible to temporally exit Demo Mode by pressing
a key and return to the GPS Chart Plotter normal operation. If a key in not touched for 30
seconds the Demo Mode will re-start.
To disable the Demo Mode follow the procedure above selecting OFF at point 5.
CP390i and CPF390i
S
], [P
P V
ULL
CREEN
I
IEW
NOTE
NOTE
NOTE
], [A
S
]. From now
UTO
WITCH
P
] again.
ID
AGE
Page 29
Advertisement
Table of Contents
