Cp390I Connection Table; Cp390I Connections - Standard Horizon CPF390i Owner's Manual

The GPS Chart Plotter can send many sentences to external NMEA devices*. The NMEA Output
wires are yellow and white. If you have connected devices as shown in the table on the next page
and need to feed NMEA to other devices (Autopilot, RADAR...) you can parallel wires from the
yellow, brown or white wires to other devices.
2.4.0

CP390i Connection Table

12VDC Power Cable
Pin Wire Color Description
1 Black Battery Ground
2 Red Battery Positive
3 Green NMEA Common
4 Blue Port 1 Input
5 Brown Port 1 Output
6 Grey Port2 Input
7 White Port2 Output
8 Yellow Port 3 Output
NMEA ACC 2 Cable
Pin Wire Color Description
1 Black NC
2 Red NC
3 Green NMEA Common
4 Blue Port 4 Input
5 Brown Port 4 Output
6 Grey Port 5 Input
7 White Port 5 Output
8 Yellow NC
*NOTE
RS232 not opto-isolated electrical interface.
2.4.1

CP390i Connections

2.4.1.0 DC Power Connection
CP390i
CP390i and CPF390i
NOTE
Connection Example
Connect to Battery Ground
Connect to Battery Positive
Common (ground) for NMEA devices*
Connect to Output of NMEA devices*
Connect to Input of NMEA devices*
Connect to FF525
Connect to FF525
Connect to Input of NMEA devices*
Connection Example
Common (ground) for NMEA devices*
Connect to Output of NMEA devices*
Connect to Input of NMEA devices*
Connect to Output of NMEA devices*
Connect to Input of NMEA devices*
Optional
WAAS GPS
Antenna
Additional Comments
Default is NMEA0183
Default is NMEA0183 with GGA, GLL, RMC,
XTE, DBT, DPT, MTW, VHW sentences
Default is Fish Finder
Default is Fish Finder
Default is NMEA0183 with APA, APB, BOD,
GGA, GLL, RMC and BOD sentences
Additional Comments
Default is NMEA0183*
Default is NMEA0183 with GLL, RMB, RMC
and XTE sentences
Default is NMEA0183
Default is NMEA0183 with GLL, RMB, RMC
and XTE sentences
ACC 2 Cable - Not used
Red
Black
PWR & ACC 1 Cable
Switch
-
+
2A
Battery
Fuse
10-35Vdc
Page 21