Table of Contents
Advertisement
To activate this function:
AUTOMATIC CHECK
ROUTE WIDTH
DEPTH LIMIT
ACCURACY
ROUTE CHECK REPORT
Although the functionality is called Route Check, it can also be activated when the navigation is set
to a single point (like DSC, MOB, Mark). In the case of checking a single point towards which the
navigation is started, the leg for which the Route Check is executed is defined by the current position
(the leg's starting point) and the destination point (the leg's ending point).
CP390i and CPF390i
Figure 9.8.0 - Example of dangerous objects found on the chart
Turns the Route Check feature On or Off. Turn the Automatic Route Check on after you
have created a new Route, or if you inserted a new Waypoint, deleted, moved or edited
any Waypoint in a saved Route to confirm the Route can be safely navigated.
This selection allows you to select the width from the left and right of the Route leg where
the GPS Chart Plotter will check to confirm navigation threats. See the picture below. The
default for this selection is 0.04NM.
This selection allows you to select the water depth in the Route width area so the GPS
Chart Plotter can check and confirm underwater threats. It checks if some objects with
the depth attribute (like Shallow Water, Dredged Areas, Diffusers, Obstructions, Pingos,
Production Installationand Wrecks) are above this depth level. Only if the depth attribute
is above the depth limit are they found and considered as dangerous. See the picture
below. The default setting is 10FT.
Defines a segment length into which a leg of the Route is divided in order to execute the
search for dangerous objects with better accuracy. When accuracy is maximal, a
segment length is the shortest. When accuracy is minimal, a segment length is the
longest. Selects among Minimum, Low, Medium, High and Maximum. See the picture
below. The default setting is Medium.
Shows the list of the dangerous objects found on the charts crossed by the Route.
F
E
C
A
B
D
Figure 9.8.0a - Route Check parameters
WAAS 3D
NOTE
A-B = Width
C-D = Depth
E-F = Accuracy
Page 83
Advertisement
Table of Contents
