Waas/Egnos Setting; Setup Menu - Standard Horizon CPF390i Owner's Manual

The WAAS/GPS Icon area may change due to the satellite reception:
ACQUIRING : the GPS is trying to receive a valid position fix.
GPS2D : The GPS is receiving at least 2 valid Satellites
GPS3D : the GPS is receiving at least 3 Satellites.
WAAS 2D/3D : the GPS is receiving a 2D or 3D position and the correction from the WAAS Satellite.
HDOP : Horizontal Dilution of Precision
VDOP : Vertical Dilution of Precision

12.5.0 WAAS/EGNOS Setting

From this page it is possible to disable the WAAS/EGNOS function following this procedure:
1.
Press [MENU], move
[ENT].
2. Press and hold
3.
Move the ShuttlePoint knob to highlight DIFF CORRECTION SOURCE and press
[ENT].
4.
Move the ShuttlePoint knob to highlight None (to disable) and press [ENT].
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.

12.5.1 Setup Menu

From this page it is possible to activate the GPS Setup menu following this procedure:
1. Press [MENU], move the ShuttlePoint knob to enter GPS STATUS page
[ENT].
2. Press and hold
following table:
Internal GPS
Restart GPS
Navigation Speed
Speed Filter
Differential Correction Source : Allows setting what kind of Differential Correction will be used by the GPS between
3.
Move the ShuttlePoint knob to highlight the preferred item and press [ENT].
4.
Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.
Page 104
the ShuttlePoint knob to enter GPS STATUS page
[ENT]. The GPS SETUP menu appears on the screen.
INTERNAL GPS
RESTART GPS
NAVIGATION SPEED
NAVIGATION FILTER
DIFF CORRECTION SOURCE
Figure 12.5.1 - Setup menu
[ENT]. The GPS SETUP menu appears on the screen. See the
: Enables (On) or disables (Off) the Internal GPS. The default setting is On.
: Restarts all GPS processes. Once executed, the message "Done" is shown.
: Allows setting the Navigation Speed among Low and High. The default setting is High.
: Allows to resolve erratic speed readings in rough seas. Available values are Off, Low,
Medium, High. The default setting is Off.
WAAS-EGNOS and none. The default setting is WAAS-EGNOS.
Off
On
High
WAAS/EGNOS
and press
and press
CP390i and CPF390i