Table of Contents
Advertisement
AUTO INFO Off
12.0.6 Display Mode
Selects from a pre-defined table what cartographic objects are displayed and which display
options are set. Pre-programmed settings are user selectable from Full, Medium, Low,
Radar (reduces the information on the display to simulate items that would be shown on a
RADAR display. Please note this function is not actually showing RADAR information it is
only showing what typically would be shown by a separate dedicated RADAR display),
Tides, Custom (default mode).
To change to one of the pre-programmed settings:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight CHART CONFIGURATIONS and press [ENT]
or move the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob up or down to select the preset and press [ENT].
5. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
The table below shows the selections for each mode:
Setting
Place Names
Name Tags
Nav Aids & Light Sectors
Attention Areas
Tides & Currents
CP390i and CPF390i
Figure 12.0.5 - Example of Auto Info settings
CHART CONFIGURATION
Figure 12.0.6 - Display Mode settings
Full
Medium
On
On
On
Off
On
No Sectors
On
On
On
Off
AUTO INFO On Points
Low
Radar
On
On
Off
Off
No Sectors
No Sectors
Off
Off
Off
Off
AUTO INFO On All
Tides
Custom
(Default values)
On
On
Off
Off
Off
On
Off
Off
On
On
Page 97
Advertisement
Table of Contents
