Table of Contents
Advertisement
3.1.5
Selecting North Up or Course Up
The default selection is COURSE UP: the top of the Chart page oriented so it will always
show the area ahead of the direction your vessel is travelling.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight COURSE UP/NORTH UP and press [ENT] or
move the ShuttlePoint knob to the right.
4. Another popup window will be shown with NORTH UP and COURSE UP, move the
ShuttlePoint knob to the desired selection and press [ENT] or move the ShuttlePoint
knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
When the CP390i and CPF390i are in Course Up mode a small arrow icon
Chart page indicating North.
3.2
AUTOMATIC TIME
The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or
Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct time, first
you must figure out the offset and if it is Daylight Savings Time. For example on the West coast of
the United States or Pacific Standard Time the offset needed would be –08:00 or –07:00 for Daylight
Savings Time, Eastern Standard Time –05:00 or –04:00 for Daylight Savings Time.
Page 36
Figure 3.1.5 - Course Up/North Up menu
NOTE
will be shown on the
CP390i and CPF390i
Advertisement
Table of Contents
