Goto Cursor, Route And Mark - Standard Horizon CPF390i Owner's Manual

7.4

GOTO CURSOR, ROUTE AND MARK

The CP390i and CPF390i can easily be set to start navigating to the Cursor on the chart
page, a saved Mark or a Route that was created.
GOTO CURSOR
1. Move the ShuttlePoint knob to the exact position you want to navigate to.
2. Press [GOTO] and a GOTO popup window will be shown.
3. Move the ShuttlePoint knob to highlight CURSOR and press [ENT].
4. The GPS Chart Plotter is now navigating from your current position to the location
selected at step 1. A bearing line between the vessels location and the destination point
is shown. A popup window shows the Distance (DST) and Bearing (BRG) from the
vessels location to the destination point. Soft Keys are also shown that allow you to
quickly switch to the Highway page, to Route Check or to stop navigation.
5. Moving the ShuttlePoint knob, the popup window disappears.
CP390i and CPF390i
Figure 7.4 - GOTO menu (1)
Figure 7.4a - GOTO menu (2)
Figure 7.4b - GOTO menu (3)
WAAS 3D
WAAS 3D
WAAS 3D
Page 73