Table of Contents
Advertisement
6. The GPS Chart Plotter is in Cursor mode, to switch to Home mode press [CLR] so the
vessel will stay in the center of the page.
7. To STOP Navigation, press [GOTO] and a WARNING window is shown. Move the
ShuttlePoint knob to highlight STOP and press [ENT].
GOTO ROUTE
When a Route is shown on the Chart page, move the cursor over the designed Waypoint
and press [GOTO]. For more information about Routes refer to Section 9.
GOTO MARK
1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)
on the Chart page.
2. Press [GOTO] to show the GOTO popup window.
3. Move the ShuttlePoint knob to highlight MARK and press [ENT] to show the MARKS/
WAYPOINTS List.
4. Move the ShuttlePoint Knob to the highlight the desired Mark or Waypoint and press
[GOTO].
5. You will notice a circle is drawn around the Icon Symbol. This means the GPS Chart
Plotter is now navigating to the point.
6. Press [CLR] to switch to the Chart page or Highway page to start navigating to the point.
Page 74
Figure 7.4c - Warning window
CP390i and CPF390i
Advertisement
Table of Contents
