Creating Marks; Creating A New Mark Using The Chart Page; Editing A Mark - Standard Horizon CPF390i Owner's Manual

Gps chart plotters / fish finder
Hide thumbs Also See for CPF390i:
Table of Contents

Advertisement

7.

CREATING MARKS

Definitions:
MARK
Can be a stand alone position or be linked to a Route. A Mark is place on the Chart Page
using [MARK] or by entering in information in the MARK/WAYPONTS menu and selecting
NEW MARK.
WAYPOINTS
Always linked to a Route. Are placed on the Chart page using [ROUTE].
The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are
also deleted.
b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.
7.0

CREATING A NEW MARK USING THE CHART PAGE

1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the Cursor and a popup window
is shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect press [E
name and icon type.Refer to Par. 7.1 for details.
1
Mark placed under Cursor
Lat/Lon of Mark, DST/BRG
2
from vessel location
Press Soft Key to show
3
Marks/Waypoint List
to move or to delete Mark
4
Vessel location
After entering in all the Marks it is a good practice to back up the points to an User C-CARD. Refer
to Section 11.
7.1

EDITING A MARK

If a Mark has previously been created and you wish to Edit it, move Cursor over the top of
the Mark.
1. After a Mark is created press [E
CP390i and CPF390i
NOTE
] that will allow you to change the position, Mark
DIT
4
1
the
, to edit,
3
Figure 7.0 - Mark creation
NOTE
] to show the edit popup window.
DIT
2
Page 69

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp390i

Table of Contents