GRAUPNER mz-24 HOTT Operating Instruction page 65

- CH OUT TYPE
It is used to set the type of receiver's signal output and it consists of ONCE, SAME, SUMO 12,
SUMI, and SUMD HD12.
> ONCE: This type is applied to the analog servo. "20msec" is automatically set to PERIOD in
RX SERVO setup
> SAME: This type is usually applied to the digital servo. You need to "10 ~ 20msec" to
PERIOD. In case that the analog servo is connected, you need to set "20msec" to
PERIOD.
> SUMI: The receiver set to SUMI take the output signal from the receiver set to SUMO and
outputs the signal.
> SUMO: Only the selected channel outputs the signal of all channels of receiver. In case that
1 receiver is set to SUMO and the other receiver is set to SUMI and then they are
connected in ex code, the receiver set to SUMI take the output signal from the re-
ceiver set to SUMO and it is operated at the same time. The final channel of receiver
is the output channel of SUMO, but you may change to the desired channel.
> SUMD HD: The digital output signal of all channels in receiver is outputted from the selected
channel. It is used to the product that needs the receiver digital signal such as
Power box and Flybarless system. The factory default for SUMD HD output
channel is the last channel of receiver, but you may change it
Touch "SET" icon to activate the value in red and select the desired type with INC and DEC
buttons. Touch "SET" icon again to deactivate the value. Touch INC button to move the
cursor to "CH OUT TYPE"
In order to set for CH OUT TYPE, touch "INC" icon to move the cursor to CH OUT TYPE
and then touch the "SET" icon. Now, "SAME" in CH OUT TYPE is activated in a red. When it
is activated, touch the INC or DEC icons to select the desirable receiver type and then touch
the "SET" icon to remove the cursor. The set type of receiver is activated.
When you select SUMO 8 and SUMD HD8 and try to select the different output channel,
touch "SET" icon to activate the channel number in red then select the desired channel with
INC and DEC buttons. Touch "SET" icon again to deactivate the value. Now, the selected
channel outputs PPM signal.
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
65