GRAUPNER mz-24 HOTT Operating Instruction page 84

1
ACT CTL
A B
Touch
1
ACT CTL
A B
Touch
ACT CTL
A B
Touch
Telemetry
84
1
Touch
ACT CTL
A B
1
ACT CTL
A B
Touch
Touch
ACT CTL
A B
6-2. Curve mixing type
In the prog.mix page, touch "NEXT" icon to call the next page and touch "INH" icon in the
cross line of NO7 and ACT to switch to "ON". Touch "NONE" in MST line to access the channel
selection page and touch and activate "NONE" icon to select the desired channel of MST and
SLV. Touch "BACK" icon to return to the prog.mix page. Touch ">>" icon to call the program
mixing setup page. Now, you need to set CTL function.
- CTL setup with a switch
Touch "ON" icon in CTL line to call "Select" message popup then move the switch with your
choice then that switch is designated as on/ off switch and then the switch direction setup
page appears. You may select ON or OFF by touching icons. When the switch is moved to the
direction of ON, the function is operated. Touch "BACK" icon to return to the program mixing
setup page.
- CTL setup with a stick
Hoping that you would refer the explanation as explained above
Here, you need to set the operation value, "L" and "H" points are set by default and you need
to mark 5 points between "L" and "H" on graph first and then adjust the operation curve with
"DEC", "INC", X-axis and Y-axis buttons. Touch "ST OFF" icon to switch to "ST ON" then the
blue line appears on graph. Move throttle stick to place the line at the desired position then
touch "ENT" icon on the bottom right. Now the new point is marked in graph. You may set five
points in your favorable position. Touch ST ON" to switch to "ST OFF" and complete the point
setup. Now touch "DEC" or "INC" button to select point and touch X-axis or Y-axis to activate
and then touch DEC" or "INC" button to adjust the operation curve.
Touch
Touch