GRAUPNER mz-24 HOTT Operating Instruction page 43

8. S.Limt (Swash Limit)
This function makes transmitter recognized the square
stick travel to a circular stick travel. Even the channels
of PITCH, AILE and ELEV which controls the swash
plate are driven to out of circle, servos are operated in
the setup circle only.
Servo EPA should be set over 100%, if the circle size
is over 100%
The Swash rotation function in the bottom is used to make the swash that mz-24 doesn't
support available by rotating the swash angle
In the Function page, touch "S.Limit" icon to call "S.Limit" setup page. Touch "INH" icon in
"ACT" line to switch to "ON" then the default value, 100% sized circle appears. Now, touch
"100%" icon in SET line to activate in blue. Adjust the cirvle size with "INC" and "DEC" buttons.
Touch "00'" icon in "Swash rotation" in the bottom to activate in blue then the swash angle is
set with "INC" and "DEC" buttons. Touch "BACK" icon to return to "FUNCTION" page.
Touch
Telemetry
Touch
Touch
9. S.MIX (Swash mixing)
S.MIX typically corrects swash plate timing issues by mixing AILE>>ELEV, ELEV>>AILE,
PITC>>AILE, PITC>>ELEV.
This function can be adjusted for each condition of Q.LINK.
• AILE>>ELEV: It is used when a helicopter is UP or DOWN while controlling aileron.
Touch
• ELEV>>AILE: It is used to suppress the adverse yaw to left or right while controlling elevator.
• PITC >>AILE: It is used to suppress the adverse yaw to left or right while controlling pitch.
• PITC >>ELEV: It is used when a helicopter is UP or DOWN while controlling pitch
In function page, touch "S.MIX" icon to call S.MIX setup page. Touch "INH" icon in ACT line to
switch to "ON" and touch >> icon to call the mixing setup page. Touch and activate the values in
LEFT and RIGHT line and adjust the mixing value with "INC" and "DEC" buttons. The programmed
values are indicated in the left graph. The soft or rough movement can be adjusted by touching
the values in EXP line, (+) value will make it smoothly and (-) value will make it roughly. You may
watch the servo operation by touching " SERVO" icon in the right top. Touch "BACK" icon to return
to S.MIX setup page. Now, you need to set CTL function. Touch "On" icon to call "Select" message
popup then move the switch with your choice then that switch is designated as on/ off switch and
then the switch direction setup page appears. You may select ON or OFF by touching icons. When
the switch is moved to the direction of ON, the function is operated. Touch "BACK" icon to return to
Touch
S.MIX setup page and confirm the setup data. Touch "BACK" icon to return to FUNCTION page
Touch
Touch
Telemetry
43