GRAUPNER mz-24 HOTT Operating Instruction page 49

- CTL setup with a stick
Hoping that you would refer the explanation as explained above
Touch
Here, you need to set the operation value, "L" and "H" points are set by default and you need
to mark 5 points between "L" and "H" on graph first and then adjust the operation curve with
Touch
"DEC", "INC", X-axis and Y-axis buttons. Touch "ST OFF" icon to switch to "ST ON" then the
blue line appears on graph. Move throttle stick to place the line at the desired position then
touch "ENT" icon on the bottom right. Now the new point is marked in graph. You may set five
points in your favorable position. Touch ST ON" to switch to "ST OFF" and complete the point
setup. Now touch "DEC" or "INC" button to select point and touch X-axis or Y-axis to activate
and then touch DEC" or "INC" button to adjust the operation curve.
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
49