GRAUPNER mz-24 HOTT Operating Instruction page 36

Q.LINK (Hold)
Touch
If you touch OFF icon in Curve line, it is switched to ON and the operation curve is smoother. After
setup, touch "TRIM" icon in the top right to call the pitch, throttle curve trim setup page.
Touch
In the pitch, throttle curve trim setup page, you may designate the pitch, throttle curve control with
DV1, DV2, DV3, DV4, SL1 and SL2 so that you can control servo movement with throttle curve
control such as the hovering in normal Q.Link and IDLE 1, IDEL 2 Q.Link.
Touch "NONE" icon in CTL line to call "Select" message popup then move the switch that you want
to use then that switch is designated to the pitch, throttle curve trim switch. After CTL setup, touch
and activate "NONE" icon in MIXER line to select the pitch curve or the throttle curve. Touch and
activate "L" icon in POINT line to select the point number with INC and DEC buttons. Now, if you
move the designated switch, the selected point follows the switch's movement. After POINT setup,
touch and activate the value, "1", in Q.LINK line to set Q.LINK number then the pitch, throttle curve
trim is activated within the setup Q.LINK. Touch "BACK" icon to return to FUNCTION page.
36
Q.LINK (idel-up2)
TRIM
TRIM
Telemetry
TRIM
TRIM
TRIM
TRIM
Touch
Touch
Touch
Touch
Touch
Touch
Touch