Detecting Vrm Devices; Configuring Nvrs - Bosch MBV-BPRO-45 Configuration Manual

Bosch Video Management System
2.
3.
To scan the network:
1.
2.
3.
4.
5.
6.
7.4

Detecting VRM devices

7.5

Configuring NVRs

Main window >
This chapter provides information on how to configure NVRs in your system.
Primary NVRs record the images of all assigned encoders and IP cameras connected to your
system.
A Failover NVR is a server that takes over the tasks of a failing Primary NVR. The Failover NVR
starts recording as soon as the Primary NVR fails. A Failover NVR cannot have any encoders
directly assigned. A Failover NVR can take over the tasks of a Primary NVR even when
Management Server is not available.
You can assign maximum one Failover NVR to a Primary NVR and you can assign multiple
Primary NVRs to one Failover NVR.
Bosch Sicherheitssysteme GmbH
Click a cell to change the desired address. For changing multiple devices, select the
desired rows. You can select multiple devices by pressing the CTRL- or the SHIFT-key.
Then right-click the selected rows and click Set IP Addresses... or click Set Subnet
Mask... to change the corresponding values.
You must enter the correct subnet mask before changing an IP address.
Click OK.
Click .
The NVR & Decoder Scan dialog box is displayed and all available NVRs, decoders, and
encoders are detected.
The detected decoders are listed in the Decoders list and assigned automatically to the
tree item of the Device Tree. If no analog monitor group has already been created,
the detected decoders are added to a new analog monitor group under
If you do not want to use a decoder or an NVR, remove the item manually: right-click the
item and click Remove.
The detected NVRs are assigned automatically to the
In the Unassigned Encoders list, select an encoder and drag it to an NVR in the Assigned
Encoders and NVRs list. The encoder's cameras are recorded on the selected NVR.
Repeat the above step for every detected encoder that you want to be part of your
system. Encoders that you do not drag to an NVR, are completely invisible in Bosch VMS.
Click Next >.
If required, a dialog box is displayed for changing the device names of the connected
devices of the detected IP devices to be used for display. Bosch VMS names the devices
with default names. If desired, you can use the existing names of the devices.
Make the required settings. For changing the displayed device names of a complete
column at once, right-click a column with check boxes and click Select Column.
Click Finish.
Devices
Configuration Manual
Configuring devices | en
>
tree item of the Device Tree.
2013.03 | V1 | Configuration Client
61
.