Table of Contents
Advertisement
190
en | Encoders / Decoders page
DNS server address
Type the IP address of the DNS server for this device.
Units listed on a DNS server are easier to access. To establish an Internet connection to the
device, it is sufficient to enter the name of the device - used in the DNS server - as URL in the
browser. Secure and dynamic DNS servers are supported.
Video transmission
Select TCP as protocol for units used behind firewalls. Select UDP for units used in a local
network.
Note:
–
–
HTTP browser port
Select the HTTP browser port from the list. The default port is 80. To limit connection to
HTTPS, deactivate the HTTP port. To do this, select Off.
HTTPS browser port
To limit browser access to encrypted connections, choose an HTTPS port from the list. The
standard HTTPS port is 443. Select the Off option to deactivate HTTPS ports and limit
connections to unencrypted ports.
The camera uses the TLS 1.0 protocol. Ensure that the browser has been configured to
support this protocol. Also ensure that Java application support is activated (in the Java Plug-
in Control Panel of the Windows Control Panel).
To limit connections to SSL encryption, set the Off option in the HTTP browser port, the RCP+
port, and Telnet support. This deactivates all unencrypted connections allowing connections
on the HTTPS port only.
Configure and activate encryption for media data (video, audio, metadata) on the Encryption
page.
RCP+ port 1756
Select On to allow unencrypted connections on this port. Select Off to allow only encrypted
connections (not supported).
Telnet support
Select On to allow unencrypted connections on this port. Select Off to allow only encrypted
connections (not supported).
Interface mode ETH 1 / Interface mode ETH 2
If necessary select the value for the interface, for example 100 Mbps HD. This value is device
dependent and must be set individually.
Network MSS [Byte]
Enter the maximum segment size (MSS) for the IP packet's user data.
This setting allows you to adjust the size of the data packets to the network environment and
to optimize data transmission. Observe the MTU value of 1514 bytes in UDP mode.
iSCSI MSS [Byte]
Enter the Maximum Segment Size (MSS) for a connection to the iSCSI system.
The maximum segment size for a connection to the iSCSI system can be higher than for the
other data traffic via the network. The size depends on the network structure. A higher value is
only useful if the iSCSI system is located in the same subnet as the device.
MAC address
Displays the MAC address.
2013.03 | V1 | Configuration Client
UDP supports multicast. TCP does not. The Maximum Transmission Unit (MTU) value in
UDP mode is 1514 bytes.
Bosch VMS NVR only supports UDP.
Configuration Manual
Bosch Video Management System
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
