Table of Contents
Advertisement
124
en | Configuration examples
15.4
Adding and configuring 2 Dinion IP cameras with VRM
recording
This section describes how to add 2 Dinion IP cameras for VRM recording, how to configure
different recording settings and how to configure Forensic Search for these cameras.
Prerequisite:
VRM and iSCSI devices are properly configured.
This means:
–
–
To add the IP cameras to an existing VRM:
Main window >
1.
2.
To add the IP cameras to the Logical Tree:
Main window >
4
To change camera properties:
Main window >
1.
2.
To configure recording settings for the cameras:
1.
2.
3.
4.
5.
2013.03 | V1 | Configuration Client
The VRM is added to the Device Tree.
An iSCSI device with configured target and LUN is assigned to this VRM.
Devices > Expand
Right-click
and click Add Encoder.
The Add Encoder dialog box is displayed.
Type the IP address of the IP camera and select the encoder type (Dinion IP).
Click OK.
Repeat this step for the other IP camera.
Maps and Structure
Drag the cameras to the Logical Tree.
Cameras and Recording >
In the Live Video column, configure the quality of live display. For these devices, you can
only set the live quality per camera, not schedule dependent.
Make the appropriate settings in the other columns.
Click a schedule tab, for example
In the
column, click a cell and select the appropriate stream quality.
Under Continuous or Prealarm Recording, in the Select column, select the desired
recording mode.
If you click Prealarm: Click a cell in the Duration column to select the alarm recording
time before the alarm in seconds.
Under Alarm Recording, in the Duration column, click a cell and type the desired
recording time.
Repeat the previous steps to configure the recording settings for the other camera.
.
Configuration Manual
Bosch Video Management System
>
tab
Bosch Sicherheitssysteme GmbH
Advertisement
Table of Contents
