Rs422 And Can Connector; Gnss External Antenna Rf Connector; Event And 1Pps Connectors (Optional) - Javad DELTAGNSS Receiver Operator's Manual

Specifications
Connector Specifications
GNSS Board Details

RS422 and CAN Connector

The RS422/CAN connector is a sealed receptacle, M12, 8 pin Male receptacle, FM, M16x1.5,
flying lead connector Binder-USA p/n 09-3481-700-08 (Figure A-5)
Table A-7 gives the RS422/CAN connector specification.
Number
1
2
3
4
5
6
7
8

GNSS External Antenna RF Connector

The external antenna connector type is a TNC RF connector with an Applied Engineering Product
p/n . RF input from LNA, 100 mA at 5.0 volts DC output.
6001-7051-003

EVENT and 1PPS Connectors (Optional)

The EVENT and 1PPS connectors are coaxial female receptacles of BNC series, Kings
Electronics part number KC-79-108. These connectors are optional.
86
2 1
3
8 7
4
6
5
Figure A-5. RS422 and CAN Connector
Table A-7. RS422/CAN Specification
Signal Name Dir
PWR IN P
GND -
422_TX+ O
422_TX- O
422_RX+ I
422_RX- I
CAN_H I/O
CAN_L I/O
Details
Bus power
Signal ground
Port TX+ line
Port TX- line
Port RX+ line
Port RX- line
CAN_H bus line (dominant high)
CAN_H bus line (dominant low)
www.javad.com