Page 1
Version 1.0 Last Revised January 26, 2015 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved.The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
JAVAD GNSS products. It is designed to ARE PROVIDED “AS-IS.” THERE ARE NO OTHER assist owners with the use of DELTA-3 and its use is WARRANTIES. JAVAD GNSS DISCLAIMS ANY subject to these terms and conditions (the “Terms and IMPLIED WARRANTY OF MERCHANTABILITY Conditions”).
DELTA-3 Regulatory Information or single computer. You may not assign or transfer the Software or this license without the express written The following sections provide information on this consent of JAVAD GNSS. This license is effective until product’s compliance with government regulations.
864 GNSS channels of this receiver allow tracking be receivable within Japan), and the Beidou Compass all current and future satellite signals. DELTA-3 is the (Chinese Global Navigation Satellite System), increas- only receiver in the market that can track and decode ing the number of satellites your receiver can detect, the QZSS LEX signal messages.
DELTA TriPad The STAT (status) LED displays the number of tracked satellites. • Green – eight and more satellites. • Yellow – five to seven satellites. • Red – less than five satellites. • No light – no satellites. www.javad.com...
Data and power ports DELTA-3 saves the last power status and restore it after voltage loss. The DELTA receiver can be equipped according us- ers needs and have different ports on the front and back Power supply requirements panels.
To check the status of the internal batteries, view the site. If downloading the program(s) from the website, BAT LED or check the status using JAVAD GNSS soft- extract the program’s files into a folder on your hard ware. Check the BAT LED for battery status.
Establishing an USB connection transmits this information via radio (UHF or GSM) to the Rover receiver. Make sure the computer has JAVAD GNSS’s USB The Rover receiver applies correction information driver installed (available from www.javad.com) be- from the Base station to its current location to accu- fore continuing.
Page 10
Figure 10. Elevation mask 6. To set up the base station, open the Base tab and set the following parameters: Antenna Phase Center Position (APC) - enter latitude, longitude, and altitude (ellipsoidal height) values of the antenna position. Do www.javad.com...
Page 11
RTK position (for the epoch to which the newly received RTCM/CMR message corresponds) or the current stand-alone po- sition (while waiting for new RTCM/CMR messag- Figure 13. Ports tab es coming from the base). www.javad.com...
Note: For detailed description of settings and parameters see NetView Software Manual.. TriPad Configuration The DELTA-3’s simple user interface (TriPad) con- Figure 15. Funktion Key sists of two keys (Power and Record) and two LEDs • TriPad “FN” Button Action - This drop-down list that control and display the receiver’s operation.
To start survey DELTA-3 should be set up on a tripod The Base station must be set up, logging data, and or in a pole. transmitting data before setting up the Rover receiver.
Page 14
(for example, JAVAD • To begin collecting data, press and hold the FN GNSS Justin).
As JAVAD GNSS releases firm- Usually, the receiver will start to output the coordi- ware updates, loading these updates into the receiver nates of the antenna’s phase center along with the solu-...
Press and hold the power button for about 4 to Loading OAFs 8 seconds. Release the power button while con- JAVAD GNSS dealers provide customers with OAF tinuing to hold the FN button. files. For any OAF related questions, E-mail at sup- •...
Order a new OAF with the desired options activated to enable or extend validity of the corresponding re- Check This First! ceiver options. Contact your dealer or visit the JAVAD Before contacting JAVAD GNSS support, check the GNSS website for details.
Page 18
RTK solutions. Check that the radio modem’s antenna is undamaged. Incorrect Base coordinates entered If damaged, contact your JAVAD GNSS dealer to re- place the antenna. Specify the correct coordinates for the Base station using NetView or another suitable field data collection The specified baud rate is incompatible with the baud software.
Power Source and have an output rated for 4,5...35 V DC, not less than 2A. This may not be the same range as other JAVAD GNSS products with which you are familiar. Warning: To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instruc- tions unless you are qualified to do so.
The purchaser’s sole remedy shall be replacement as If this product has been dropped, altered, transport- provided above. In no event shall JAVAD GNSS be lia- ed or shipped without proper packaging, or otherwise ble for any damages or other claim including any claim...
Need help?
Do you have a question about the DELTA-3 and is the answer not in the manual?
Questions and answers