Javad DELTAGNSS Receiver Operator's Manual page 36

Configuration
Configuring the Receiver
Parameter
Baud rate
RTS/CTS
Figure 3-7. Base and Rover Configuration for RTK – Ports - If external modem is used
10. Click the Advanced tab and then the Multipath tab. Set the following parameters and click
Apply (Figure 3-8 on page 37).
• Code multipath reduction – enable
36
Base Receiver
Select a baud rate to use for transmitting differential messages from
the receiver board to the modem module.
The baud rate must match the modem's serial port speed.
Select to enable handshaking.
Rover Receiver
www.javad.com