On-Hook Dialing; Permanent Caller Id Block Release - Cisco 7960 User Manual

speakerphone/handset microphone back on. On the 7960 SCCP, the LCD displays
the messages "Microphone Mute On" or "Microphone Mute Off" for three seconds
when you turn on or off (respectively) the mute function.

On-hook Dialing

You can dial a number while the handset is on-hook by doing one of the following:
•
•
•
•
•
•
•
TIP: You can pick the handset up at any time to conduct a private
conversation.

Permanent Caller ID Block Release

If you chose to have your caller ID information blocked on all calls, this feature
allows your caller ID information to be sent for this call only.
Your caller ID may be required for some calls to be completed. If your call will not
be accepted without caller ID information you may get a message that the number
you called will not accept anonymous (no caller ID) calls. You may use this feature
to send caller ID information for that call only.
To allow your caller ID to be displayed on the phone you are calling:
1. Press *82.
NOTE: On the 7960 MGCP phone, you may skip the next step.
2. Press the Dial soft key, or line or SPEAKER button, or pickup the handset.
3. Dial the desired phone number.
The called number should either ring or be busy. You should not get the
anonymous call rejection message.
40 System Telephone Features
Dial the phone number on the keypad and:
•
on the 7960 SCCP, press the Dial soft key, or
•
pick up the handset, or
•
press the SPEAKER button, or
•
press a line button.
Press the desired line button and dial the number.
Press the SPEAKER button and dial the number.
Press a speed dial button.
Press the Redial soft key.
Press the Intercom (Intcom) soft key.
Press the NewCall softkey and enter a number.
Cisco 7960/7940 Telephone User Guide
620-05600230