Table of Contents
Advertisement
5
Chapter
CARE AND MAINTENANCE
CAUTION
• Be sure to unplug the machine before cleaning
it. Otherwise, injury may result.
Cleaning the LCD
If the surface of the LCD is dirty, lightly wipe it with a soft dry
cloth.
Cleaning the machine surface
When wiping dirt off the machine, firmly wring a soft cloth
soaked in (lukewarm) water.
After cleaning the machine, dry it with a soft, dry cloth.
Restrictions on Oiling
In order to prevent damaging this machine, it must not be
oiled by the user. This machine was manufactured with the
necessary amount of oil applied to ensure correct operation,
making periodic oiling unnecessary.
If problems occur, such as difficulty turning the handwheel or
an unusual noise, immediately stop using the machine, and
contact your authorized Brother dealer or the nearest Brother
authorized service center.
Precautions on Storing the Machine
Do not store the machine in any of the locations described
below, otherwise damage to the machine may result, for
example, rust caused by condensation.
*
Exposed to extremely high temperatures
*
Exposed to extremely low temperatures
*
Exposed to extreme temperature changes
*
Exposed to high humidity or steam
*
Near a flame, heater or air conditioner
*
Outdoors or exposed to direct sunlight
*
Exposed to extremely dusty or oily environments
Note
• In order to extend the life of this machine,
periodically turn it on and use it. Storing this
machine for an extended period of time without
using it may reduce its efficiency.
APPENDIX
CARE AND MAINTENANCE
Cleaning the Race
a
Press
(Needle position button) to raise the needle.
b
Turn the main power to OFF, and then unplug the
machine.
c
Remove the needle and embroidery foot (page 29,
page 111).
d
Remove the bobbin cover.
e
Slide the needle plate cover toward you to remove it.
Note
• If the embroidery unit is attached, the needle plate
can be removed when the bobbin cover is
removed.
f
Grasp the bobbin case, and then gently lift out.
g
Use the cleaning brush or a vacuum cleaner to remove
any lint and dust from the race and bobbin thread
sensor and the surrounding area.
c
1 Cleaning brush
2 Race
3 Bobbin thread sensor
IMPORTANT
• Do not apply oil to the bobbin case.
5
a
109
Advertisement
Table of Contents
