Jtag Connector (P2); Battery Connector (P3); Expansion Interface Ii Connectors (P4-5) - Analog Devices ADSP-BF592 EZ-KIT Lite Manual

JTAG Connector (P2)

The JTAG header (
face and ADSP-BF592 processor.
Pin 3 is missing to provide keying. Pin 3 in the mating connector should
have a plug.
When an emulator is used with the EZ-KIT Lite, the on-board debug
agent is bypassed.

Battery Connector (P3)

is a connection point of a single 3.3V lithium ion battery. Ensure that
P3
the positive lead of the battery is inserted to the side labeled
negative terminal is inserted to the side labeled
leads, press the white plastic button in and slide out the lead. The battery
is not connected until the
Part Description
Wire to board, push-in, 16-28
AWG
3.7V lithium ion battery,
950mAh
Expansion Interface II Connectors (P4–5)
and are board-to-board connectors providing signals for the SPI,
P4 P5
TWI, UART, SPORT, and GPIO signals of the processor. The connec-
tors are located on the upper edge of the board (one connector is on the
top and one is on the bottom). For more information, see
Interface II" on page
ADSP-BF592 EZ-KIT Lite Evaluation System Manual
ADSP-BF592 EZ-KIT Lite Hardware Reference
) is the connecting point between the JTAG inter-
P2
switch is
SW22
Manufacturer
WEIDMULLER
Mating Battery
MOUSER
1-11.
. To remove the battery
–
.
ON
Part Number
281-2020-ND
5169-UBP563450
"Expansion
, and the
+
2-21