Sport0 Enable Switch (Sw1); Uart Setup Switch (Sw2); Battery Switch (Sw3) - Analog Devices ADSP-BF592 EZ-KIT Lite Manual

SPORT0 Enable Switch (SW1)

The SPORT0 enable switch (
SPORT0 interface of the processor and allows the SPORT0 signals to be
used on the expansion interface. Refer to
for more information.

UART Setup Switch (SW2)

The UART setup switch (
connector ( ) and processor.
J1
turned on. See
information.
Table 2-3. UART Setup Switch (SW2)
SW2 Position
1 and 3
2
4
5
6 and 7
8

Battery Switch (SW3)

The battery switch (
from the EZ-KIT Lite power. When the switch is
from the battery. Jumper
default, is
SW3
ADSP-BF592 EZ-KIT Lite Evaluation System Manual
ADSP-BF592 EZ-KIT Lite Hardware Reference
SW1
) configures UART signals between the DCE
SW2
Table 2-3
"DCE UART Connector (J1)" on page 2-20
Function
Enable flow control
Disconnects the
the
UART_RX
Connects the
Allows the host to reset the EZ-KIT Lite via the
Selects the source for the
Loopback mode. Connects the
mode is for testing only.
) connects and disconnects the lithium ion battery
SW3
must be removed when
JP7
.
OFF
) disconnects the codec from the
"Audio Interface" on page 1-9
shows operation of the switches
signal from the processor;
UART_RX
signal can be used for another function
and signals together
RTS CTS
signal
CTS
and
RX
ON
for more
signal
CTS
signals together. This
TX
, the board can run
is . By
SW3 OFF
2-7