Reset Push Button (Sw7) - Analog Devices ADSP-BF592 EZ-KIT Lite Manual

interfaces with devices operating at above 100 kHz frequency, turn
to prevent the bus from hanging. By default,
OFF
Table 2-5. Table 10. Fuel Gauge Select Switch (SW6)
SW6 Position
1
2
3
4

Reset Push Button (SW7)

The reset push button (
The reset push button does not reset the on-board debug agent. The reset
push button does not reset the following ICs.
• SPI flash (
• Audio codec (
• UART0 (
• Fuel gauge (
The reset push button does not reset the debug agent once it has been
connected to a PC. The USB chip is not reset when the push button is
pressed after the USB cable has been plugged in and communication with
the PC has been initialized correctly. After USB communication has been
initialized, the only way to reset the USB chip is by powering down the
board.
ADSP-BF592 EZ-KIT Lite Evaluation System Manual
ADSP-BF592 EZ-KIT Lite Hardware Reference
Function
BAT_GD
BAT_LOW
SCL
SDA
) resets the processor's ICs via a hardware reset.
SW7
)
U4
)
U7
)
U12
)
U17
is all .
SW6 OFF
SW6
2-9