Native Instruments Maschine Getting Started Manual page 75

2. Now select an empty Group with an empty Sound Slot, let's say Sound 1. Select it by
pressing its pad.
3. Press Button 5 to select the Source tab (
4. By using buttons 5 & 6 or Knob 5 you can select between
. Select
OUT INPUT
5. To select an effect Slot, press the
pressing Button 6.
6. Press +
SHIFT BROWSE
7. Select the Reverb, and load it using Button 8. Switch back to Control mode by press-
ing the button again or pressing the
BROWSE
8. Now go back to the 909 Kit Group and select the Snare Sound by pressing pad 2.
9. Go to the Output tab (
tion: select B: INPUT 1 from the list.
→ As you can hear, the Snare is already being sent to the effect; by turning the Aux 1
Level, you can adjust the amount of signal that gets sent into the Reverb.
SRC
and press Button 8 to confirm your selection.
CONTROL
: now you see the list of the available effects.
, Button 8) and turn Knob 5 to select the Aux 1 destina-
OUT
The Input Module and Advanced Routing
). After that press
SHIFT
SAMPLER
button and then select MODULE 2 by
button.
CONTROL
MASCHINE - Getting Started - 75
Setting up a Send Effect
+ .
BROWSE
, or
INPUT MIDI