Native Instruments Maschine Getting Started Manual page 65

Hardware
1. In Control mode, press Button 2 to put the focus on the
ed on the left display, then press the
the effect to.
2. Press Button 4 to put the focus on the
3. On the right display, you can now see the Modules 1-4. Select Module 1 by pressing
Button 5.
4. To select an effect for Module 1, press
the list of the available effects.
5. On the left display, use Knob 1 to set the
for VST/AU plug-ins. The right display now shows the list of the available ef-
PLUG-IN
fects. If you want to load a VST/AU plug-in effect select
6. You can browse through them by either turning Knob 5.
7. When you've found an effect you want to apply, press Button 8 to load it.
8. Switch back to Control mode by pressing the
9. Now you can edit the effect parameters using the knobs!
GROUP
button of the Group you want to apply
GROUP
tab.
MODULES
+ . The right display now shows
SHIFT BROWSE
to
TYPE INTERNAL
PLUG-IN
mode button.
CONTROL
Using Effects & Routing
Applying Effects to a Group
tab which gets select-
for MASCHINE FX or
.
MASCHINE - Getting Started - 65