Lotus Elise S1 Service Notes page 83

Lotus Service Notes Section CG
The early type uses a split Nylon bush secured to the chassis via the lower wishbone front pivot bolt and
spacer tube, with a secondary M5 bolt clamping the two halves of the bush below the bar. Washers welded to
the anti-roll bar bear against the outer sides of the bushes to locate the bar laterally. The bush should be
lubricated on assembly with M0S2 type grease.
Excessive radial clearance between the bar and bush may cause knocking noises, which can be reduced
by removing material from the joint face of the split bush to reduce the effective diameter.
Lower Wishbone Inboard Pivots & Early Type Anti-Roll Bar Mounting
Flanged
spacer tube
Front /eg Rear leg
Bonded reinforcement
plate
Bonded inserts
Anti-roll bar
pivot block
Bonded inserts
Anti-Roll Bar Drop Link
fl
Anti-roll bar
drop link
Anti-roll bar
Lower wishbone
1998 / 02
Page 7