Lotus Elise S1 Service Notes page 532

Section XA
The driver only, competition roll over bar is available for RHD or LHD cars, and is RAC approved for
competition use in the U.K. provided that a passenger seat is not fitted in the vehicle. The roll bar is a direct
replacement for the standard 340R double hoop bar, and includes an anchorage bar for the standard fit compe-
tition seat belt harness shoulder straps.
Fitting Instructions
1. Remove the topshell (refer to Elise Service Notes section 340R.B) and the double hoop roll-over bar.
2. Fitment of the new bar requires a clearance slot to be cut in the engine lid and body aperture gutter. A
template (LSL401) for the engine lid slot is provided below to allow an initial fit to be made, with initial
dimensions for the body aperture measureable from this. The spoiler mounting plate will also require a
small clearance groove to be made to allow the backstay to be connected. The body on each car will
require individual fettling, but with care, no painting should be required.
3. Refit the driver's seat and seat belt harness. Note that with this bar fitted, a passenger seat MUST NOT
be fitted.
t?ar taQtataV
135 mm
100 mm
Page 50