Lotus Elise S1 Service Notes page 166

Cylinder head - K16 non VVC engines fitted with
plug top coil ignition system - remove
if fitted
A
NOTE: Commencing engine numbers for
these engines are listed in Information
CAUTION: If crankshaft is to be removed
I \ during overhaul it will be necessary to
check and record crankshaft end-float
a
prior to removing cylinder head.
1. Remove and discard camshaft timing belt
CAUTION: Do not rotate crankshaft whilst
l \ timing belt is removed and cylinder head
is fitted, pistons will contact the valves.
a
M124950
M124959
2. Noting that shortest screw is fitted in centre of
spark plug cover, remove 3 screws securing
cover to camshaft cover.
3. Remove spark plug cover.
4. Disconnect ht lead and plug tube from No. 4
spark plug.
5. Remove 2 bolts securing front coil to camshaft
cover.
6. Carefully raise coil until plug tube is
disconnected from No. 1 spark plug,
disconnect multiplug from coil.
7. Disconnect ht lead and plug tube from No. 2
spark plug.
8. Remove 2 bolts securing rear coil to camshaft
cover.
9. Carefully raise coil until plug tube is
disconnected from No. 3 spark plug.
10. Disconnect multiplug from coil.
11. Release harness from clips.
OVERHAUL 2 9