ENGINE
Camshafts - K8 and all K16 N o n W C e n g i n e s •
refit
K8
K16
1. Lubricate bearings and fit camshaft(s) and
position drive pin for 90° BTDC as follows:
K8: Pin at 4 o'clock.
K16: Inlet pin at 4 o'clock.
Exhaust pin at 8 o'clock.
Camshaft carrier a n d oil seal - K8 engines - refit
1. Ensure 2 locating dowels are fitted in camshaft
carrier.
2. Apply continuous, thin beads of sealant, Part
Number GUG 705963GM to paths on camshaft
carrier as shown and spread to an even film
using a roller.
CAUTION: E n s u r e sealant d o e s n o t enter
l u b r i c a t i o n g r o o v e s o n c a m s h a f t carrier
a n d that a s s e m b l y is c o m p l e t e d w i t h i n 20
minutes.
3. Lubricate camshaft cams and journals with
engine oil.
12M0563
4. Fit camshaft carrier, fit and lightly tighten bolts
using sequence shown.
5. Tighten all bolts in sequence shown to 10 Nm.
OVERHAUL
6 1