Wood Add-On; Installation Mini-Caddy Add-On; Introduction; Appliance Installation - PSG MINI-CADDY PF01301 Installation And Operating Instructions Manual

Table of Contents



3.1

WOOD ADD-ON

The wood burning Mini-Caddy Add-on furnace is approved for in-line connection

to an existing oil furnace with a firing rate of 0.8 G.P.H. (US) to 1.2 G.P.H. (US)

or any gas or electric furnace with comparable heat output. The existing furnace

must have a maximum heating capacity of 20,51 kW (75,000 BTU/h.)

Before installation, please read the instructions carefully and make sure

you understand them:

The furnace must be installed in a state of the art manner. Installation must be

made in accordance with the CSA B.365 standard concerning the normalization

of solid fuel units. If modifications have to be made to the existing furnace, these

have to be conform respectively to CSA B.139 for oil furnaces, CSA C22.1 for

electric furnace and CAN/CSA B149.1 or CAN/CSA B149.2 for gas furnaces.

Inspect the furnace to make sure that nothing has been damaged in the shipping.

Pull out the wiring kit and the instructions manual from the firebox of the furnace

and the scraper from the flue pipe.

The furnace must be installed where outside air supply will be sufficient for

proper combustion. In airtight houses, it might be necessary to install an outside

air inlet (see Section 2.12.)

The furnace must be positioned so that the connector is as short as possible.

Minimize the use of 90

elbows.

The owner must ensure a proper installation to allow a safe operation of

the appliance.

Table of Contents