Parksense Front And Rear Park Assist - If Equipped; Parksense Sensors - Chrysler 300 SRT 2019 Owner's Manual

To Cancel
The following conditions will cancel the Normal
(Fixed Speed) Cruise Control without clearing
the memory:
• The brake pedal is applied.
• The CANC button is pushed.
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• The braking temperature exceeds normal
range (overheated).
• The gear selector is removed from the DRIVE
position.
• The driver switches ESC to full-off mode.
To Resume Speed
To resume a previously set speed, push the
RES button and release. Resume can be used
at any speed above 19 mph (30 km/h).
To Turn Off
The system will turn off and erase the set speed
in memory if:
• The Normal (Fixed Speed) Cruise Control
on/off button is pushed.
• The ignition is turned OFF.
• The Adaptive Cruise Control (ACC) on/off
button is pushed.
158
PARKSENSE FRONT AND
REAR PARK ASSIST — IF
EQUIPPED
The ParkSense Park Assist system provides
visual and audible indications of the distance
between the rear and/or front fascia and a
detected obstacle when backing up or moving
forward, e.g. during a parking maneuver.
Refer to "ParkSense System Usage Precau-
tions" in this section for limitations of this system
and recommendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE or DRIVE. If ParkSense
is enabled at one of these gear selector posi-
tions, the system will remain active until the
vehicle speed is increased to approximately
7 mph (11 km/h) or above. The system will
become active again if the vehicle speed is
decreased to speeds less than approximately
6 mph (9 km/h).

ParkSense Sensors

The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors' field of view. The
sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches
(200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.
The six ParkSense sensors, located in the front
fascia/bumper, monitor the area in front of the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 47 inches
(120 cm) from the front fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.