Appendix E: Connecting Ptz Cameras - Digimerge DH100 Series Instruction Manual

Appendix E: Connecting PTZ Cameras

APPENDIX E: CONNECTING PTZ CAMERAS
You can connect RS-422/485 PTZ cameras (not included) to the PTZ Control Block on the rear
panel of the system.
Connecting a PTZ camera (not included)
To install a PTZ Camera:
1. Connect the Transmit+ Cable to the RS-485 TX (+) port of the PTZ block on the rear panel.
2. Connect the Transmit- Cable to the RS- 485 TX (-) port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (4/8-channel) or to the Octopus cable (16-channel).
4. Open the Main Menu and select PTZ Control
5. Click the number tab to select the channel that the PTZ camera is connected to.
6. Select the "Enable PTZ" checkbox.
7. Enter the PTZ's Protocol, PTZ ID and Baud Rate.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
8. Right-click and click Yes to save your settings.
110
Connect to T+ and T-
.
8-channel model shown
BNC
PTZ CAMERA
(not included)