Sensor Setup; Schedule Setup - Digimerge DH100 Series Instruction Manual

Using the Main Menu

Sensor Setup

The Sensor Setup window allows you to
configure the sensor type, and the alarm
duration.
To configure Sensor Setup settings:
1. From the EVENT SETUP window, click
Sensor Setup.
2. Configure the following:
• Alarm Duration (Seconds): Enter the
duration the system alarm continues to
activate after an event.
• Sensor Popup: When a sensor triggers, the
corresponding channel will open in full-
screen mode.
• Polarity: Select N.O (normally open) or N.C
(normally closed).
• All Off: Turns all alarm sensors off.
• All N.O: Selects all sensors as N.O
(normally opened).
• All N.C: Selects all sensors as N.C
(normally closed).
3. Right-click and click Yes to save your
settings.
30

SCHEDULE SETUP

Configure recording schedule, and
recording types.
To configure the Schedule Setup settings:
1. Click on the schedule on the left that you
wish to configure.
You can configure up to 50 schedule
NOTE:
types.
Select schedule
2. Configure the following:
• Enable Schedule Record: Select the
checkbox to enable scheduled recording.
• Enable Schedule Motion Detect: Select the
checkbox to enable motion recording.
• Enable Schedule Sensor Trigger: Select
the checkbox to enable alarm sensor
recording.
• Start Time: Enter the start time of the
scheduled recording.
• End Time: Enter the stop time of the
scheduled recording.
Start Time must come before the End
NOTE:
Time. To create a schedule where the End