Table of Contents
Advertisement
SECTION 4
PTZ Menu
Pan / Tilt / Zoom control (for Pelco D or Pelco P Model Cameras only)
1. PAN / TILT / ZOOM: Accesses the PTZ Control for a
camera. Press the
press the
SEL
• LEFT/RIGHT - Pans the camera LEFT/RIGHT
• UP/DOWN - Tilts the camera UP/DOWN
• VOL UP/DOWN - Zooms the camera IN/OUT
• SEL/MENU - Stops viewing / Exits viewing
2. FOCUS: Accesses the Focus Control for a camera.
Press the
and
button to access FOCUS controls:
SEL
• UP/DOWN - Focuses NEAR/FAR
• SEL/MENU - Stops/Exits Menu
3. SETUP: Setup of the PTZ Cameras. Press the
buttons to highlight, and press the
SETUP menu:
• CHANNEL: Select the PTZ camera location (Channel 1-4,
1-8, or 1-16 depending on model)
• ID: Set the camera ID (1-7, or OFF).
• Protocol: Select the PTZ Protocol (PELCO-D or PELCO-P)
• Baud Rate: Select the Baud Rate for the Camera (2400,
4800 or 9600 BPS)
• SAVE & EXIT: Saves any changes, and exits to the previous
menu.
Revision 1.0
PTZ (enter Password)
and
buttons to highlight, and
button to access PTZ controls:
buttons to highlight, and press the
SEL
and
button to enter the
System Set
Pan/Tilt/Zoom
Focus
Setup
PTZ Controller Set
Channel
1
ID
NO
Protocol
PELCO-D
Baud Rate
2400 BPS
Save & Exit
39
Advertisement
Table of Contents
Troubleshooting
