Camera Setup; Ptz Setup; Controlling The Ptz Camera - Digimerge DH100 Series Instruction Manual

Using the Main Menu

CAMERA SETUP

Configure camera color and
brightness properties and camera
name.
To configure the Camera Setup menu:
1. Click the channel number you wish to
configure.
2. Configure the following:
• Mask: Select the checkbox to blank out the
channel. The channel continues to record,
but you will not be able to see the channel.
• Sharpness, Brightness, Contrast,
Saturation, Hue: Click -/+ to increase or
decrease the values.
• Name: Enter the desired channel name.
• Volume (channel 1 only): Adjust the
volume input level. You must connect an
audio input device to the DVR's Audio IN
port (i.e self powered microphone or
audio-enabled camera (not included)).
3. Right-click and click Yes to save your
settings.
32

PTZ SETUP

Configure PTZ camera settings.
To configure the PTZ setup menu:
1. Click on the channel number that the PTZ
camera connects to.
2. Configure the following:
• Enable PTZ: Select the checkbox to enable
the PTZ camera.
• Protocol: Select the PTZ camera's
protocol.
• PTZ ID: Enter the PTZ ID.
• Baud Rate: Enter the PTZ baud rate.
Refer to your PTZ camera
NOTE:
manufacturer for configuration details.
3. Right-click and click Yes to save your
settings.

Controlling the PTZ camera

To control your PTZ camera:
1. Double-click the channel that the PTZ
camera connects to, so that you are in full
screen mode.
2. Right-click and click PTZ Control.
3. Use the PTZ controls to manipulate the
camera.