Event Setup; Motion Setup - Digimerge DH100 Series Instruction Manual

EVENT SETUP

Configure Motion or Sensor
configuration.
The Event Setup window has two menus —
Motion Setup and Sensor Setup.

Motion Setup

The Motion Setup window allows you to
configure motion sensitivity, the alarm
recording duration, and motion detection area.
To configure Motion Setup settings:
1. From the EVENT SETUP window, click the
Motion Setup window.
2. Configure the following:
• Alarm Duration (Seconds): Enter the
duration the system continues to record
after an event occurs.
• Motion Popup: Select the checkbox if you
want the channel that detects motion, to
"pop-up" in full screen.
• Sensitivity: Click -/+ to increase or
decrease motion sensitivity.
• Apply to All: Click to apply the settings to
all channels.
• Motion Area Setup: Opens the Motion
setup grid.
• Configure the following:
Mask Mouse Selection
•
box so that you can use the mouse cursor
to customize the grid. You can double-click
portions of the grid to de-select area if this
selection is enabled.
Select All
• : Select the entire area for
motion detection.
Deselect All
•
motion detection.
3. Click Save & Exit to save your settings.
4. Right-click and click Yes to save your
settings.
Using the Main Menu
: Select the check
: Deselect the entire area for
29