Changing The Time Zone; Configuring A Time Server; Device Setup; Buzzer & Relay Setup - Digimerge DH100 Series Instruction Manual

Using the Main Menu
3. Right-click and click Yes to save your
settings.

Changing the Time Zone

To change the time zone:
1. Click Time Zone Setup.
2. Configure the following:
• Select Time Zone: Select the desired time
zone. Choose from GMT-/ GMT/ GMT+
• Daylight Saving Time: Select or deselect
the checkbox to enable or disable daylight
saving time.
3. Right-click and click Yes to save your
settings.

Configuring a Time Server

You can enter a time server so that the DVR
automatically syncs its system time.
To configure the time server:
1. Click Internet Time Setup.
2. Select the Automatically Synchronize
checkbox.
3. Under Server, enter the time server name.
4. Click Update Now. The system provides a
success or failure message.
5. Right-click and click Yes to save your
settings.
38

Device Setup

The device setup menu allows you to adjust
system Buzzer, relay, and video output
settings.
To adjust the mouse acceleration speed:
1. Beside Mouse Speed, click -/+ to adjust
the mouse acceleration speed.
2. Right-click and click Yes to save your
settings.
Buzzer & Relay Setup
The Buzzer & Relay Setup menu allows you to
configure the type of events that will trigger a
relay (alarm block) to activate, or the system
buzzer to beep, when an event occurs.
To adjust the Buzzer & Relay Setup settings:
1. Configure the following:
• Key Tone: Select the checkbox to enable/
disable the system "beeps" when you click
the mouse.
• Buzzer: Select the events that will trigger
the system to "beep" when an event occurs
(HDD Error, Video Loss, Motion or Sensor
event).