Appendix F: Connecting Ptz Cameras - Digimerge DH230 Series Instruction Manual

APPENDIX F: CONNECTING PTZ CAMERAS

You can connect RS-422/485 PTZ cameras (not included) to the PTZ Control Block on the rear
panel of the system.
DH250 Relay block
Connecting a PTZ camera (not included). DH230 DVR shown above.
To install a PTZ Camera:
1. Connect the Transmit Cable to the RS-422/485 TX (+) port of the PTZ block on the rear panel.
2. Connect the Receive Cable to the RS-422/485 TX (-) port of the PTZ block on the rear panel.
3. Connect the video cable to a BNC port (usually channel 1).
4. Open the Main Menu and select
5. Beside PTZ, click the SETUP button. Select the model of your PTZ camera.
6. Enter the PTZ Camera's BAUD RATE.
NOTE: The PTZ camera settings depend on the type of PTZ camera. Please refer to the specific camera
manual for your brand and model of PTZ camera.
7. If desired, enter the Preset numbers (PRESET No.) and Dwell Time.
8. Press the ENTER button to save your settings.
Connect to T+ and T-
Connect to T+ and T-
.
CAMERA
Appendix F: Connecting PTZ Cameras
BNC
PTZ CAMERA
(not included)
155