Ricoh M080 Service Manual page 99

1st/2nd Message
Cannot print.
Check network Settings.
(103/203)
Classification Code Error
Connect failed:WirelessCard
Turn power off, check card.
Cover Open. Please close the
indicated cover.
Duplex mode is in off position for
(tray name)
Ethernet Board Error
Exceeded max. print size. Press
[FormFeed] or [JobReset].
Exceeded max. print size. Press
[JobReset].
Failed to connect to server for
Remote Diagnostics.
SM
Problem/Solution
Check the file you want to print is a supported file
type. Check for misfeeds and ask your network
administrator for help.
The IP address setting is incorrect. Check the IP
address, subnet mask, and gateway address.
A classification code is not specified for the print job.
Enter a classification code using the printer
properties and print the document again.
Check there is a Wireless LAN board installed.
Check that it is a supported board. If it is, check it is
installed correctly.
Install the correct board properly.
Close the cover indicated on the control panel.
The duplex mode for the indicated tray is off; you can
only use one-sided printing. Press [Change] to
change the tray's settings, press [JobReset] to reset
the job, or press [Form Feed] to force printing.
An error on the Ethernet board is detected. Pull out
and then re-install the controller board. If the problem
persists, contact your sales or service representative.
The specified paper size exceeds the maximum size
supported by this printer. Press [Form Feed] to force
printing or [JobReset] to cancel printing.
The specified paper size exceeds the maximum size
supported by this printer. Press [JobReset] to cancel
printing.
The printer cannot communicate with Remote
Communication Gate. Check the connection to the
Remote Server Gate.
6-3
Error Messages
M080