Ricoh M080 Service Manual page 173

External Controller error 5
914 D
Egret Controller error 6
001 Egret Controller Board Error
HDD Serial Communication
002
Error
003 Egret CPU Overheat Error
915 D
Egret-GW Controller
004
Communication error 1
Egret-GW Controller
005
Communication error 2
External Controller Down Error
While EAC (External Application
Converter), the conversion module,
was operating normally, the receipt
919 B
of a power line interrupt signal from
the FLUTE serial driver was
detected, or BREAK signal from the
other station was detected.
Printer error 1
An internal application error was
920 B
detected and operation cannot
continue.
SM Appendix
The external controller alerted the
machine about an error.
Please refer to the instructions
for the external controller.
Egret controller board defective
Egret HDD cable defective
Egret HDD defective
Replace Egret controller board
Replace GW controller board
Egret-to-GW controller board
cable defective
Egret controller board defective
GW controller board defective
Power outage at the EFI
controller
EFI controller was rebooted
Connection to EFI controller
loose
Software defective; turn the
machine off/on, or change the
controller firmware
Insufficient memory
2-25
Service Call Conditions
M080