Ricoh M080 Service Manual page 65

7. Fusing Lamp [A] (
The colored cable must be at the hot roller gear side.
8. Guide plate [B] (3 hooks)
9. Hot roller strippers [C] (1 spring x each)
10. Hot roller [D] (2 x C-rings, 1 x gear, 2 x bushings)
Before removing the hot roller from the unit, remove the gear and the pin first,
Use a small screwdriver to separate the guide plate from the unit.
Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the
protective sheet on the new hot roller. Be sure to remove the remaining paper
before starting the machine.
SM
x 2)
4-17
Fusing
M080