Ricoh M080 Service Manual page 214

Printer Engine Service Mode
5816 209 Instl Clear
5816 250 Comm Log Print
Note: The proxy number, user name, and password comprise proprietary customer information
required by the service technician to do the necessary settings for Cumin-N. To prevent
unauthorized access this information, these SP settings do not appear in the SMC report.
Remote Service A(ddress)
5821
5821 1 CSS-PI Device Co(de)
5821 2 RCG IP Address
Paper Supply for DFU
5823
An @Remote setting. Not required for service technician.
NVRAMUpload
Uploads the UP and SP mode data (except for counters and the serial
5824
number) from NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents
a software module accessing the NVRAM during the upload.
M080
-2397 Incorrect ID2 format
-2398 Incorrect request number format
Releases the machine from its embedded RCG
setup.
Prints the communication log.
Sets the PI device code. After changing this
setting, you must switch the machine off and
on.
Sets the IP address of the RCG (Remote
Communication Gate) destination for call
processing at the remote service center.
[00000000h to FFFFFFFFh/00000000h/
3-36 SM Appendix