Ricoh M080 Service Manual page 100

Error Messages
1st/2nd Message
Independent-supply toner
IPDS font error. Turn power
switch off then on. Select Reset
IPDS Fonts in Maintenance.
IPv6 Address already exists
Link-local Address(109/209)
IPv6 Address already exists
Stateless Address(109/209)
IPv6 Address already exists
Manual Config.
Address(109/209)
Load paper in (tray name) or
[Cancel] to FormFeed.
Option RAM Error
Output tray is full.
Parallel I/F Error
Prepare Replacement Check
print cartridge replacement(s).
Printer Font Error.
M080
Problem/Solution
Independent-supply toner is set. Use toner
recommended for this printer.
IPDS font error has occurred. Perform the shutdown
procedure, and then turn off the power of the printer.
Turn on the power again, and then execute [Reset
IPDS Fonts].
The same IPv6 address already exists. Consult your
network administrator.
The same IPv6 address already exists. Consult your
network administrator.
The same IPv6 address already exists. Consult your
network administrator.
There is no paper in the specified tray. Load the
specified paper in the tray, press [JobReset] to reset
the job.
The printer cannot detect an optional SDRAM
module. It may be incorrectly installed.
Check if it is installed properly.
The output trays are full. Remove the paper.
The printer's self diagnostic test failed due to a
loopback error. Replace the IEEE 1284 board that
caused the error.
The toner has run out, or the photo conductor unit
has reached the end of its service life. Prepare a new
print cartridge.
There are problems with the printer's font file.
Contact your sales or service representative.
6-4 SM