Ricoh M080 Service Manual page 216

Printer Engine Service Mode
5828 065 Job Spool
5828 066 HD job Clear
5828 069 JobSpool Protocl
This SP determines whether job spooling is enabled or disabled for each
protocol. This is a 8-bit setting.
0: LPR/ 1: FTP (Not Used)/ 2: IPP/ 3: SMB/ 4: BMLinks (Japan Only)/
5: DIPRINT/ 6: Reserved (Not Used)/ 7: Reserved (Not Used)
5828 090 TELNET
5828 091 Web
5828 145 ActIPv6LinkLocal
5828 147 ActIPv6Sttles1
5828 149 ActIPv6Sttles2
5828 151 ActIPv6Sttles3
5828 153 ActIPv6Sttles4
M080
Switches job spooling spooling on and off.
0: No spooling, 1: Spooling enabled
This SP determines whether the job interrupted at
power off is resumed at the next power on. This SP
operates only when SP5828 065 is set to 1.
1: OFF (Resumes printing spooled jog.)
0: ON (Clears spooled job.)
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0to1/1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0to1/1]
0: Disable
1: Enable
This is the IPv6 local address referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured
in 8 blocks of 16 bits each. These notations can be
abbreviated. See "Note: IPV6 Addresses " below this
table.
These SPs are the IPv6 stateless addresses (1 to 5)
referenced on the Ethernet or wireless LAN (802.11b)
in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured
3-38 SM Appendix