Ricoh M080 Service Manual page 102

Error Messages
1st/2nd Message
Set the Fusing Unit correctly.
Set the Print Cartridge correctly.
Supply order has failed.
This NetBIOS name is already in
use.(108/208)
The same IPv4 Address already
exists.(102/202)
The selected job has already
been printed or deleted.
USB has a problem. Please call
service.
Values set for IPv6/Gateway
addresses are invalid.(110/210)
WPA Auth. incomplete.(211)
M080
Problem/Solution
The fusing unit may not be installed correctly. Turn
the printer off and re-install the fusing unit.
If the message is still displayed after re-installation,
contact your sales or service representative.
The print cartridge may not be installed correctly.
Turn the printer off and re-install the print cartridge.
If this message is still displayed after re-installation,
contact your sales or service representative.
The automatic supply order failed. The message
indicates the supplies that the printer tried to order.
The NetBIOS name specified for the printer is already
in use by another device on the network. Consult
your network administrator.
The IPv4 address specified for the printer is already
in use by another device on the network. Consult
your network administrator.
This message might appear if you print or delete a
job from Web Image Monitor. Press Exit on the
message screen.
The printer has detected a USB board failure. Turn
the power off, and then on again. If the problem
persists, contact your sales or service representative.
The IPv6 address or gateway address is invalid.
Check the network settings.
WPA authentication could not complete. Consult your
network administrator.
6-6 SM