Table of Contents
Advertisement
Software settings
Operating Instructions 610/630 - 00.0 - 05/2014
7.7 Programming mode
Fig. 44: Programming mode
Header (1)
The operating mode EDIT is displayed. Using the buttons TF on
or TF off, the tape feed is switched on and off (only 610 sewing
machine).
Left-hand area (2)
The graphic display of the entire seam is shown here, divided into
the programmed number of segments.
Central area (3)
Here existing seam programs can be modified pg. 88.
The number and the name of the selected seam program and the
icons of all adjustable parameters are displayed. The gray fields
above the parameter icons display the relevant current values.
Right-hand area (4)
Here new seam programs can be created pg. 93, existing
seam programs can be deleted, pg. 103 copied pg. 103
and optimized pg. 104 (Length Correction).
87
Advertisement
Table of Contents
